Watch microphone or radio-speaker audio from 20 Hz to 20 kHz with an FFT, peak hold, and waterfall. Not an RF spectrum analyzer. Works offline after your first visit.

← All tools · CTCSS tones · DTMF pad

Audio Spectrum Analyzer

See sound from about 20 Hz to 20 kHz: a microphone, an audio file, or a built-in test tone. Hold a radio speaker near the mic to watch voice, a CTCSS tone, DTMF, or a digital-mode trace. This does not scan ham-band RF, and the levels are dBFS, not calibrated watts or sound pressure.

DisplayReal-time FFT, peak hold, and waterfall

Pick a source above to start: your microphone, an audio file, or the built-in test signal.
Peak–
Note–
Peak level–
Signal (RMS)–
Resolution–

Drag across the display to read a frequency. Pair a CTCSS or DTMF tone from the tools above with this display, or hold the radio speaker to the microphone. Levels are dBFS (0 dB is digital full scale).

What this display is actually showing

The trace is a Fourier transform of audio in the browser. Zero on the meter is digital full scale (dBFS), so a louder mic moves the line up and a quiet one sits in the noise. Resolution depends on the FFT size: a larger size splits tones that are close together, such as a CTCSS tone near 100 Hz and the hum around it.

Useful checks: play a tone from the CTCSS generator and confirm the peak; tap the DTMF pad and look for two tones; hold an HT speaker to the laptop mic while a digital program runs and compare the waterfall with what WSJT-X or fldigi shows. None of that measures the carrier frequency, deviation, or SWR. For the antenna, use the SWR calculator and a real meter.

See also: CTCSS and DCS · FT8 frequencies · Digital emcomm

Common questions

Does this scan the ham bands?

No. It shows audio from about 20 Hz to 20 kHz — the sound from a microphone, a file, or a radio speaker. It is not an RF spectrum analyzer and it will not find a repeater or measure SWR.

How do I see a CTCSS tone or a digital-mode trace?

Play a tone from the CTCSS or DTMF tool, or hold the radio speaker near the microphone. A CTCSS tone sits near 100 Hz. FT8 and similar modes show up as moving traces in the voice range.

Are the levels calibrated?

No. Levels are dBFS, relative to digital full scale in the browser. They are not watts, dBm, or sound-pressure level.

Can I use this to find an open frequency on 2 meters?

No. The browser only hears audio. Finding a clear RF channel takes a radio in scan, or a real spectrum analyzer on the antenna port.